This is the first step you need to perform when migrating several projects in parallel. By performing the steps below you will migrate all the users along with the execution statuses that test cases and test steps can have in ALM. This is done to avoid possible issues when migrating large projects in parallel.
Note
|
1. Open your browser and enter <IP address>:<port> where <IP address> is that of the computer where you ran the .jar
file and <port> is the port number you specified when running the .jar
file. For example, localhost:44444. The Migration Wizard will open:
2. Populate all the fields on the Zephyr & HP QC Configuration page and click Save Config:
3. On the subsequent screen, review the values and update them if needed. Click Next:
4. On the next screen, select All ALM Users, Testcase & TestStep Execution Status and click Next:
All ALM users will be migrated to Zephyr along with the execution statuses that ALM test cases and test steps can have (only a set of statuses used for the test cases and steps will be migrated. No data on each step or test case will be transferred). All the migrated users will be enabled in Zephyr, even if some of them are disabled in ALM. You will be able to disable them later, if needed. Clicking Next brings up the following screen with information on the migration process:
During the migration, you can open the |
After the migration completes, the wizard will show a report:
After migrating all the users and statuses, you can start migrating your projects.