To be able to work with Zephyr Data Center, you need to install and configure Elasticsearch -- a search and analytics engine -- on a separate node. Depending on the number of concurrent users who will work with the Data Center, you may need to set up one Elasticsearch node or a cluster of nodes (see Recommended Configurations).
|
Download Elasticsearch 8.6.2 (the ZIP archive).
2. Unzip the downloaded file.
3. Configure the {elasticsearch}\config\elasticsearch.yml
file:
For more details on the configuration for-
Single node- refer to the details in ES 8.6.2
Cluster nodes - refer to the details in ES 8.6.2
4. Start the service by running the {elasticsearch}\bin\elasticsearch.bat
file.
1.Download Elasticsearch 8.6.2 (the RPM archive), or run the following command in the Linux command prompt:
For 8.6.2 use the link- wget https://artifacts.elastic.co/downloads/elasticsearch/elasticsearch-8.6.2-x86_64.rpm
2. In the Linux command prompt, run one of the following commands to install Elasticsearch:
For 8.6.2 - sudo rpm -ivh elasticsearch-8.6.2-x86_64.rpm
sudo yum localinstall elasticsearch-8.6.2-x86_64.rpm
3. Configure the etc\elasticsearch\elasticsearch.yml
file:
For more details on configuration for-
Single node- refer to the details in ES 8.6.2
Cluster nodes - refer to the details in ES 8.6.2
4. Start Elasticsearch. The way you start and stop it depends on whether your system uses SysV init or systemd.
If SysV init is used, you start and stop Elasticsearch by running the service
command:
sudo -i service elasticsearch start
sudo -i service elasticsearch stop
If systemd is used, you run the following commands:
sudo systemctl start elasticsearch.service
sudo systemctl stop elasticsearch.service
5. Run the following command to verify Elasticsearch is working properly:
curl -XGET '192.168.11.146:9200/_cat/health?v&pretty'
Set Up Zephyr Data Center
Support and Troubleshooting